Heat control
Mohamad Reza Nasresfahani; Mohamad Nasresfahani; hossein Nazemi; mojtaba forghani; hadi gorabi
Abstract
One of the most common methods to increase the adhesion of aluminum surfaces is the use of anodized coatings. However, if we heat the manufactured products before adhering due to the hydration of the anodized coating, cracking and morphological changes, the adhesive capacity will be severely reduced. ...
Read More
One of the most common methods to increase the adhesion of aluminum surfaces is the use of anodized coatings. However, if we heat the manufactured products before adhering due to the hydration of the anodized coating, cracking and morphological changes, the adhesive capacity will be severely reduced. As part of the research presented in this study, methods such as non- sealing of the anodize, primer application before heating the coating, sandblasting before and after the anodizing coating, and use of FPL (Forest Products Laboratory) replacement coating have been used to investigate the adhesive behavior of the coating. According to the results, not sealing the anodized coating and priming it before heating will increase the adhesiveness of the coating in all cases. Sandblasting after coating had no significant effect on adhesion. Sandblasting before anodizing improves adhesion by altering the texture of roughness and morphology. FPL can also be used to replace anodized coatings. They were less sensitive to heating and storage
Structure
Maedeh sadat Zoei; hadi gorabi; mohammadreza asharf khorasani; saeed asghari; S. Javid Mirahmadi
Abstract
Space systems in Low Earth Orbit (LEO) expose to the destructive parameter of atomic oxygen. In long-term missions, the rate of degradation of the material resulting from the reaction with atomic oxygen is significant and reduces the performance of the structure. Due to the harmful effects of atomic ...
Read More
Space systems in Low Earth Orbit (LEO) expose to the destructive parameter of atomic oxygen. In long-term missions, the rate of degradation of the material resulting from the reaction with atomic oxygen is significant and reduces the performance of the structure. Due to the harmful effects of atomic oxygen on materials, the choice of atomic oxygen resistant materials or the use of durable surface coatings is very common. In this study, the corrosion resistance of atomic oxygen of an interconnector part of a solar cell has studied by applying a silicone base coating. In order to investigate the corrosion behavior of atomic oxygen, ground test method with equivalent conditions of LEO orbit has used by DC plasma equipment. Initially, the parameters of the atomic oxygen corrosion ground test determined under the equivalent conditions of the LEO orbit. The results of atomic oxygen application in this study showed that the amount of atomic oxygen erosion yield of silicon coating is significantly lower than the amount of atomic oxygen erosion yield of silver substrate. The study of the coating surface after applying atomic oxygen by SEM images led to the determination of the optimal coating thickness. EDX results showed that after applying atomic oxygen, no significant change in the chemical composition of the coating has achieved
